- Ensure there is a gasket that seals the Tag Reader to the pump body.
- If there is no gasket, use silicone to seal the back of the Tag Reader.
- Fit the Tag Reader flat cable to the Tag Reader, then bolt it to the pump.
- The other end of the cable will be connected to the MID (circuit board)
Search Knowledge Base Articles
How to fit a iButton Tag Reader
Did you find this article useful?
Related Articles
-
How to Record Manual Dips
Introduction: The Importance of Manual Tank Dips While your site may be equipped with an Automatic T... -
Block / Unblock & Deleting of Attendant, Drivers and Vehicles
These profiles can be deleted, and the tag can be reassigned. The simple rule is that you must; ... -
Setup Vehicle, Makes and Types
Navigate to the "Vehicle" Menu item > Make: Enter the vehicle's make. (e.g., Massey Ferguson, Joh...